  |
|
 |
|
 |
|||
| |||||||||||
|
|
If there is a defined TNPP paging service at the server, but you wish to specify specific user parameters (CAP page), then use this command. Example NTPAGER TnppServiceCapPage -ServiceName"Acme Paging" -TnppDestId"2343" -TnppCapcode"12345678" -TnppFunction"4" -TnppType"p" -TnppClass"s" -TnppChannel"3" -TnppZone"3" -Message"This is the message to send" Note: Assumes that you have previously used the SetDefault command to set default values needed for communication with the NTpage Server. Required parameters ServiceName TnppDestId TnppInertia TnppCapcode TnppFunction TnppClass TnppChannel TnppZone Message Optional parameters EmailError WhereTo From Subject PageDelay IpAddress NamedPipeAddress DebugFile |
|
